Verdex 60pin connector chart
From GumstixDocsWiki
You can check if this connector is on your gumstix by using the reference table on the Gumstix motherboard I/O page.
Note: Schematic images and charts below are from the point of view of the gumstix looking at the connector from the daughtercard's point of view, these signals are mirrored^
This pinout is for the GS270 versions R1205, R1365, and R1511. It may be subject to change in future revisions.
| Pin | GPIO | Signal | Signal | GPIO | Pin |
|---|---|---|---|---|---|
| 1 | - | GND | - | GND | 60 |
| 2 | GPIO(67) | L_DD09 | - | USBH_N1 | 59 |
| 3 | GPIO(77) | L_BIAS | GPIO(28) | BITCLK | 58 |
| 4 | GPIO(61) | L_DD03 | GPIO(76) | L_PCLK | 57 |
| 5 | GPIO(30) | SDATA_OUT | GPIO(73) | L_DD15 | 56 |
| 6 | GPIO(66) | L_DD08 | GPIO(72) | L_DD14 | 55 |
| 7 | - | GND | GPIO(34) | FF_RXD | 54 |
| 8 | GPIO(71) | L_DD13 | GPIO(65) | L_DD07 | 53 |
| 9 | GPIO(70) | L_DD12 | GPIO(63) | L_DD05 | 52 |
| 10 | GPIO(69) | L_DD11 | GPIO(68) | L_DD10 | 51 |
| 11 | - | USBH_P1 | GPIO(59) | L_DD01 | 50 |
| 12 | GPIO(46) | IR_RXD | GPIO(113) | NACRESET | 49 |
| 13 | GPIO(60) | L_DD02 | GPIO(47) | IR_TXD | 48 |
| 14 | GPIO(100) | FF_CTS | GPIO(62) | L_DD04 | 47 |
| 15 | GPIO(9) | CLK_32 | GPIO(31) | SYNC | 46 |
| 16 | GPIO(75) | L_LCLK | GPIO(11) | SSPRXD2 | 45 |
| 17 | GPIO(17) | PWM1 | GPIO(14) | SSPSFRM2 | 44 |
| 18 | GPIO(58) | L_DD00 | GPIO(29) | SDATA_IN0 | 43 |
| 19 | GPIO(118) | SDA | - | GND | 42 |
| 20 | GPIO(117) | SCL | GPIO(74) | L_FCLK | 41 |
| 21 | GPIO(19) | SSPSCLK2 | GPIO(64) | L_DD06 | 40 |
| 22 | GPIO(87) | L_DD17 | GPIO(27) | FF_RTS | 39 |
| 23 | GPIO(13) | SSPTXD2 | - | GPIO101 | 38 |
| 24 | GPIO(41) | OTG_ID | - | N_MANUAL_RESET | 37 |
| 25 | GPIO(2)* | SYS_EN | GPIO(16) | PWM0 | 36 |
| 26 | GPIO(39) | FF_TXD | GPIO(43) | BT_TXD | 35 |
| 27 | GPIO(86) | L_DD16 | GPIO(45) | BT_RTS | 34 |
| 28 | - | V_BATT | GPIO(42) | BT_RXD | 33 |
| 29 | - | V_BATT | GPIO(44) | BT_CTS | 32 |
| 30 | - | V_BATT | - | GND | 31 |
